4/7/2021 0 Comments Gesichert Luger Serial Numbers
Conclusions: Mauser produced frames only as from 1934, until that time DWM frames were used.Many members have been so kind to give me the SNs and basic properties of the pistols they own, or that they been have able to find in other sources.In view of my promise that I would also publish these on this forum, you find hereunder the actual results of my research.
Gesichert Luger S Serial Number Between 1VThese might help when studying a Mauser commercial or contract Luger having a Serial Number between 1v and 9999v.This is only an interim report, I did not find yet answers to all the questions, so please go on sending me the properties of any Mauser Luger within this Series that is not yet reported correctly in the listing. Updates, Revisions: When new information becomes available the information below wil be updated. In 1928, the BKIWDWM management proposed to cut the nominal value of the shares in half. ![]() They decide to nominate Gnther Quandt, the successful managerowner of the AFA battery factory, as the new president of this board. Gnther Quandt started an investigation of the situation of the BKIWDWM concern. It showed out that the activities were far from profitable, reorganization was inevitable. DWM was not at all happy to lose the Luger production and Mauser was secretly working on a pistol that should replace the Luger as the official Army sidearm. ![]() Having a dull barrel band (mostly mounted on the U series) b. Having a sharp barrel band, as seen on the Dutch Navy Lugers (DWM 1928-1930). Conclusions: DWM made barrels with a sharp barrel band as from 1928. They were mounted on the Dutch East Indies and Navy contracts, and also on the v suffixed series that came assembled and CN proofed from Berlin to Oberndorf. DWM mounted barrels with a dull barrel band on the Lugers of the U series that came assembled from Berlin to Oberndorf, but some pistols of these series were reported to have a sharp barrel band too. Many barrels with a sharp barrel band came as readied parts from DWM to Mauser. It is not known if Mauser produced any barrels with a sharp barrel band in Oberndorf. The barrels that unmistakenly are produced by Mauser, have a dull barrel band. Mauser produced frames have always a dimple (hole) on top of the stock lug rail. ![]() A bit more complicated is the difference between the DWM and Mauser frames as the top rear end of the frame is examined. In 1931 the German Army published ordnance, stating that the frame of the P.08 pistol should be lengthened with 1 millimeter, in order to prevent the toggle axle of escaping during the uppermost position of the toggle. Here are the figures: Frame length DWM made: 129.0mm (5.078) Frame length Mauser made: 130.0mm (5.118) The Ordnance was implied by Mauser in 1934, when the K-date Military Lugers were produced.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |